Siemens tumble dryer Belt 1980 H7 / 1980H7

How to repair your appliance? Experts will help you...

To remedy this situation, you can adjust the belt tension using the special key provided with yoru dryer. Simply loosen the pulley screws slightly, then gently pull on the belt to tighten it further. Once the tension is correct, tighten the screws again to hold the belt in place. On the other hand, if you find that your dryer is not heating enough, it is possible that the heating thermostat is defective. First, unplug the dryer from the electrical outlet for safety reasons. Then, remove the back panel of the dryer using an appropriate screwdriver. Locate the heating thermostat, which looks like a small cylinder with connected electrical wires. Disconnect the electrical wires from the thermostat, being careful to note their placement. Then, remove the defective thermostat and securely install the new one. Replace the back panel of the dryer and plug it back into the electrical outlet. You should now notice an improvement in the heat produced by your dryer. Finally, if your dryer makes an abnormal noise during operation, it is possible that the drum bearing is worn out. To replace it, you will need to follow these steps. First, unplug the dryer from the electrical outlet. Then, remove the back panel of the dryer using an appropriate screwdriver. Locate the drum bearing, which is usually located at the back of the dryer. Unscrew the bearing fixing screws and remove it from the dryer. Install the new bearing by securely fastening it with the fixing screws. Replace the back panel of the dryer and plug it back into the electrical outlet. Your dryer should now operate without any annoying noise.