1163 PJE / 1163J5EL drive belt

How to repair your appliance? Experts will help you...

The washing machine is placed in the normal washing position, then it performs some movements to arrange the laundry and starts to fill up. After filling, when it reaches the selected level, it sometimes starts the motor by initiating the washing cycle and when it reaches the draining, it does so and performs the function, and when it reaches the rinsing to fill up again, it stops and releases. The lid lock then proceeds to execute the beginning of the normal washing cycle, then fills up and starts the motor for agitation and follows the normal washing cycle, draining through the pump and respective filling returning to follow the cycle, but when it drains to start the spin, it also produces the defect. Now, yuo don't know how to solve this problem. First, check the hot and cold water solenoids and everything is fine until the temperature sensor. Then, check the motor noting that the capacitor is defective and replace it with a similar one. Also, check the belt and test the motor without load and note that it consumes more than what the plate indicates in amps. The motor is for max 3.7 amps and empty should be around 2 to 2. Additionally, check the actuator or cylinder and note that it has a light and a sensor. XXX_BRAND_XXX seems good and not tested to know its operating voltage and optical reading. Also, check the rotating wheel and lubricate it with grease where it deserves it, but without exaggerating. XXX_BRAND_XXX the tube or drum is smooth and does not feel tight or worn. Finally, you notice that only three LEDs light up, indicating washing, rinsing, and spinning. XXX_BRAND_XXX is good to go.