Tip of the day

The drum of your washing machine AEG turns but when you put too much laundry in, the drum cannot turn. It is possible that the weight is too heavy and the belt cannot drive the drum. It is possible to change the capacitor because its cost is not important. If the problem persists when the capacitor is replaced, remove the motor and test it outside the washing machine.
If the motor works normally, the malfunction is due to the programmer. You should also check the condition of the bearings: try to turn the transmission pulley manually to see if there is any resistance when handling.
The belt has just been changed but it does not turn properly. Check to see if it is tight enough. If it is not, the belt will come off its axis the first time you use the washing machine. Use a screwdriver to pry and tighten the screws. To check that the belt is tight enough, rotate the large pulley and see if the belt is sticking out from the edge of both pulleys. If it does, apply pressure to the edge of the belt while manually turning the drum pulley, then manually drive the large pulley for several turns. If the belt on the washing machine AEG drives the pulley correctly, it is correctly tightened.