Tip of the day

The belt of the washing machine has already been changed, but after several wash cycles the drum does not work anymore. Remove the belt and check whether the rotation of the agitator is light or not. If you notice that it is difficult to move it, then the washing shaft is partially engaged. Despite changing the motor, the unit does not have enough power. The capacitor has been changed. Due to the change of capacitor, it is necessary to remove the belt and, with a piece of wood, gently and gradually press the motor pulley. If it cannot counteract this braking force and stops when touched, the bearings are defective. Put grease on the bearings so that they do not jam during their action. Prepare a container for draining the water and collect any remaining water by disconnecting the water inlet hose from the rear wall. If there are no problems with the sensors and wiring, insert the belt onto the motor shaft and then onto the pulley by running it with one hand and pulling on the belt with the other. The belt will snap into place on its own. Program a wash cycle to check the drum rotation, then reassemble the back panel of the washer.