Tip of the day

The washing machine has stopped running. After checking, the condenser is in good condition. You have done a spin but the drum does not rotate. First check that the pump vanes are not loose, that the hose to the pressure switch is not clogged or obstructed, and if you don't check the motor, the spin winding may be defective. Try removing the belt and starting the motor in spin mode. Check that the solenoid valve closes when it should not be running. If it is leaking water, it will not turn. The solenoid valve is where you connect the charging hose. Remove the hose and blow through the protruding part of the valve and make sure it is completely closed. The air doesn't have to go through. Remove the belt to see if the motor is running smoothly through the spin cycle. Check the pulleys for damage. Get a new belt. To loosen the belt a bit for easier installation, soak it in very hot water for a few minutes. Start by positioning the belt around the small motor pulley. Hold it with one hand so it doesn't come off, then position the belt along the drum pulley until the belt becomes difficult to tension. While holding the belt on the small pulley, rotate the drum pulley so that the belt fits properly. Tension the belt.